Instruction Manual

36
The mV Setup menu allows the user to set the parameters associated with mV and Relative mV
measurements.
Accessing mV Setup
• Press
while in Measure mode and then or
to select mV / mV Rel range.
• Press and then to access mV Setup menu.
To access a mV Setup option:
• Use or to highlight the desired option.
• Press to access the selected option.
The following is a detailed description of the mV Setup option
screens.
Profile – See pH Setup section.
Temperature – See pH Setup section.
Sample ID – See pH Setup section.
Stability Criteria – See pH Setup section.
Reading Mode – See pH Setup section.
Log – See pH Setup section.
Alarm – See pH Setup section.
Note: The Alarm Limits (Low and High) are set in mV units.
mVmV
mVmV
mV
SETUP SETUP
SETUP SETUP
SETUP
81
TDSTDS
TDSTDS
TDS
SETUP SETUP
SETUP SETUP
SETUP
The TDS Setup menu allows the user to set the parameters related to the TDS measurement.
Accessing TDS Setup
• Press while in Measure mode and then to
select TDS range.
• Press and then to access TDS Setup menu.
To access a TDS Setup option:
• Use or to highlight the desired option.
• Press to access the selected option.
The following is a description of the TDS Setup option screens.
Reading Mode - see Resistivity Setup section.
Profile - see Conductivity Setup section.
Temperature - see Conductivity Setup section.
Units
This option allows the user to set the TDS measuring range
ppm(mg/L), ppt(g/L), AutoRanging
To select the suitable unit:
• Use or to highlight the TDS Units .
• Press to confirm and then use or
to highlight the convenient measuring range option.
• Press to confirm your selection or press to
cancel operation.