User Manual

Select No TC in order to display actual conductivity (no temperature

compensation).

Select MTC in order to automatically compensate conductivity using the

set temperature coefficient with the temperature manually selected by

the user.

Select ATC in order to automatically compensate conductivity using the

set temperature coefficient with the temperature read from the sensor

inside the EC probe.

Range Select

Focus on the

Range Select

item.

Press Modify to select ranging mode.

Use the ARROW keys to change selection.

Press Accept to confirm or ESC to exit without saving. If “Automatic” is

selected the instrument changes the range automatically according with

the input.

If one of the range is selected all the readings are displayed on the

corresponding range.

The readings will be displayed with maximum 6 digits. If the reading

exceeds the maximum number of digits for the fixed range, the maximum

value is displayed blinking.

Note: The Range Select parameter can be set only in EC, resistivity and

TDS range.

Cell constant

Focus on the

Cell Constant

item.

Press Modify to change the cell constant value.