User Guide

Note The default password is set at “0000”.

• The LCD will display “SET” on the up-

per part and “c.00” on the lower, al-

lowing the user to edit setup param-

eters (see table below).

• Using the arrow keys as for the above password proce-

dure, enter the code of the parameter to set, e.g. 41.

• Confirm the code by pressing CFM and the default or the

previously memorized value will be displayed with the

first digit blinking.

Note When the password is not inserted or a wrong password is

confirmed, the display will only show the previously memo-

rized value, without blinking (read only mode). In this case,

the value cannot be set. Press LCD and start again.

• Enter the desired value using the arrow keys and then press

CFM.

• After confirmation, the selected parameter is

displayed. The user can scroll through the

parameters by pressing CFM.

• In order to directly set another param-

eter, press SETUP again and enter the

code or scroll to it by pressing CFM.