User's Manual

13 (0x0D)
2
30
(1) Wait time for clearing the PIR triggered (default 30
seconds) If there is no trigger during this time, it will send
Notification （Notification Type is Home Security，
Event is 0，Parameter 1 is Motion Detection Unknown
Location）to its associated node.
(2) effective value：10～3600 s
14 (0x0E)
1
1
When the PIR is triggered，send basic command or not。
0 － Don’t send
1 － Send Basic Set command 。
15
（0x0F）
1
0
When PIR is triggered , send Basic Set：
0 － When PIR is triggered, send 0xFF； no PIR
triggered， send 0x00.
1 － When PIR is triggered, send 0x00； no PIR
triggered ,send 0xFF.
16(0x10)
1
1
When PIR is triggered, send” Binary Sensor Report” or
not (Sensor Type：Motion )。
0 – don’t send
1 – send
18(0x12)
1
2
The default unit for temperature report。
1- degrees Celsius
2- Fahrenheit
19
（0x13）
1
1
When motion is detected, the indicator light on or off.
0 – turn off
1 – turn on
32
(0x20)
1
10
Low battery alarm value, Unit is percent，when battery
power is less than this value，Battery Report 0xff
effective value：10~50
172
(0xAC)
2
4 H
(240 minutes)
Interval time of automatic report of battery power,
Temperature, Humidity and Light (unit: hour)
Effective value: 0x0001～0x02E8(1～744 hours)
(31days=31*24= 744) ;
182
(0xB6)
1
5
Threshold value to enable battery power report when the
battery’s changed value exceeds the threshold set.
effective value：0~50% (0x00～0x32)；
0:this threshold value doesn’t work;
1-5: 5%，
6-10: 10%，etc.