Owner's Manual

02.Pairing: Launch KAT Gateway,
click 'Device Manager', and select
'Pair Sensor'. Then, follow the
instructions on the screen and
connect the sensors to your PC
one by one according to the
prompts to complete the pairing.
02
The lighting signals described below signalize different
operation modes of your KAT loco:
Recharging: Diming light
Fully charged : Long bright signal
Low power: Flashing with a long break
Pairing: Quick flashing
Firmware updating: flashing
Unpairing: Slow flashing
Sleep Mode/Power-off: Light off
Left and Right Ankle Sensors: Firstly, find the L/R signs on the
sensors symbolizing which leg should you put them on. The sensor
with left light on should be placed on your left ankle and vice versa.
20