User's Manual
Caution
Red indicator: when it is on, it means the power supply to the KATVR-Back Sensor is normal but it
is not connected to the KATVR-Central. Green indicator: when it is on, it means the KATVR-Back
Sensor is connected to the KATVR-Central Sensor.
34 Starting Installation
KATVR-Back Sensor
1 Working status indicator
2 Charging status indicator
3 Red switch button
4 Micro USB charging interface
5 Six-digit red dialer
1.οΎ
Dial the 6-digit red dialer of KATVR-Back Sensor to match that of KATVR-Central Sensor. When dialing,note the distinction
of the digital direction and the position of ON, on the encoder.
2. Dial the six-digit red dialer for the wireless receiver to the same position as that for the two KATVR-Foot Sensor.
3.
Connect one end of the USB-A type extension cable for the wireless receiver to the receiver and insert the other
end into the USB port of the PC.
4.
Insert the other end of the KATVR-Top Sensor connecting cable into the KATVR-Top Sensor port on the side of the
KATVR-Central Sensor.
5.
Connect one end of the USB-A type extension cable to the KATVR-Central Sensor and insert the other end into the USB
port of the PC.