User's Manual

56 Dismantling and Replacement
Attention
1.Make sure all the power is off and that all the power connections are cut off prior to the dismantling.
2.As the device is very heavy, it requires at least three male adults to do the dismantling.
3.Please do follow the above procedures to do the dismantling for safety purposes.
4.Please properly keep all the items dismantled, including screws, cotter pins, etc.
5.As the internal wires are fragile, please do not forcibly dismantle.
Dismantling and Replacement of KAT STATION Control Center Components
KAT STATION is a customized control center for the KAT WALK PREMIUM. To make sure the KAT STATION works properly,
please do not randomly open the cabinet or replace the internal components.
Please contact KAT service center if there is any problem during the use of the product.
Please contact KAT service center before component dismantling in case the warranty for your KAT STATION is affected.
KAT SHOES Replacement Instructions
Procedures of Replacing Sliders
The sliders and the wheels are of embedded design, and when replacing them
1.Hold the two ends of KAT SHOES to turn the sole outward while squeezing the SHOES inward.
You are advised to replace it when the wheel at the rear of the KAT SHOES sole is loose or cannot roll properly
You are advised to replace it when the slider on the KAT SHOES sole is seriously abraded.
As the first slider is more prone to abrasion than the second one, you may also swap the two first before the replacement.
You are advised to replace KAT SHOES when the shoe surface is abraded.