User's Manual

55 Dismantling and Replacement
Dismantling and Replacement of KAT WALK PREMIUM
Component
Dismantling Shell
1.Remove the pedals and unscrew all the screws on the base plate shell; carefully dismantle the light source cable of
the base plate to separate the shell.
2.Unscrew all the screws on the side and back of the lower part of the support pillar to separate the shell of that part.
3.Unscrew the screws on the side of the upper part of the support pillar.
4.Unscrew the screws on the metal sheet parts of the middle part of the support pillar to separate the metal sheet parts.
Dismantling Mechanical and Electrical Structure:
1.Open the hatch cover of the HTC head-mounted display; unplug the original cable (HDMI, USB and DC cable), and the
earphone connecting cable may remain there; properly place the HTC head-mounted display.
2.Unplug the HDMI cable and the USB cable that connect the KAT WALK PREMIUM and the KAT STATION, and the DC
cable that connects the KAT WALK PREMIUM and the power socket.
3.Turn the base plate holder to move the KAT WALK PREMIUM to a flat and open field.
4.Unscrew the installing screws on the installing plate of the connecting rod to dismantle the rod.
5.Dismantle the base plate and the support pillar shell one by one for the KAT WALK PREMIUM.
6.Turn the fastening screws on the bottom of the support pillar, and make sure one person holds the pillar on its back
to prevent it from suddenly toppling.
7.Put the pillar down backwards so that it lies flat down on the ground; a foam pad of over 20cm thick should be placed
under the pillar in advance.
8.Dismantle the girder casing cover and turn the screw at the connection between the cover and the girder to take it off.
9.Hold the three-in-one data cable in the HTC head-mounted display on the telescopic stick, pull the cable out of the
girder and take out the part of the data cable in the telescopic stick and the three-in-one data cable in the head-mounted
display.
10.Remove the fastening screws on the flange between the support pillar and the girder, and turn the girder to make it
parallel with the ground.
11.Turn the flange between the support pillar and the girder to separate them.
12.Put the support pillar upright, unscrew the fastening screws on the hinges at the connection between the support
pillar and the base plate, turn the hinges, and separate the pillar from the base plate with at least two persons holding
up the pillar.
For your safety
Please make sure all the power is off prior to dismantling.
Attention
The shell is made up of special materials, and thus you may easily dismantle it by simply removing the screws.
Please do not forcibly dismantle the shell to prevent it from being damaged.