Data Sheet

9 APPENDIX-STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an uncon-
trolled rolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
Important Note
This radio module must not installed to co-locate and operating simultaneously with
other radios in host system except in accordance with FCC multi-transmitter product
procedures. Additional testing and equipment authorization may be required to
operating simultaneously with other radio.
The availability of some specific channels and/or operational frequency bands are
country dependent and are firmware programmed at the factory to match the in-
tended destination. The firmware setting is not accessible by the end user.
The host product manufacturer is responsible for compliance to any other FCC rules
that apply to the host not covered by the modular transmitter grant of certification.
The final host product still requires Part 15 Subpart B compliance testing with the
modular transmitter installed.
The end user manual shall include all required regulatory information/warning as
shown in this manual, including: This product must be installed and operated with
a minimum distance of 20 cm between the radiator and user body.
This device have got a FCC ID: 2ANDL-WBR3T. The final end product must be labeled
in a visible area with the following: “Contains Transmitter Module FCC ID: 2ANDL-
WBR3T”.
This device is intended only for OEM integrators under the following conditions: 1)
The antenna must be installed such that 20cm is maintained between the antenna
and users, and 2) The transmitter module may not be co-located with any other
transmitter or antenna.
As long as 2 conditions above are met, further transmitter test will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed.
Declaration of Conformity European notice
27 / 28