Product Manual

19
WB8P datesheet
This device is intended only for OEM integrators under the following conditions:
1）The antenna must be installed such that 20cm is maintained between the antenna and users, and
2) The transmitter module may not be co-located with any other transmitter or antenna.
As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM
integrator is still responsible for testing their end-product for any additional compliance requirements
required with this module installed.
ISED Compliance
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following
two conditions:
1) This device may not cause interference.
2) This device must accept any interference, including interference that may cause undesired
operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1) L’appareil ne doit pas produire de brouillage;
2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
ISED 20cm RF Exposure
The device should be installed and operated with a minimum distance of 20 cm between the radiator
and your body.
L'appareil doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre
corps.
This device have got a IC：23243-WB8P.The final end product must be labeled in a visible area with
the following: “Contains Transmitter Module IC：23243-WB8P”