Data Sheet

TYWE2Lv1.0.2 Datasheet

杭州涂鸦信息技术 Version1.0.2

7.Certification

FCC Statement

This device is intended only for OEM integrators under the following conditions:1) The antenna

must be installed such that 20 cm is maintained between the antenna and user.2) The transmitter

module may not be co-located with any other transmitter or antenna.

Module Antenna Type: 2.4GHz onboard PCB PIFA Antenna, 2.5dBi peak gain.

15.19

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference. (2) This device must accept any

interference received, including interference that may cause undesired operation.

15.21

Note: The grantee is not responsible for any changes or modifications not expressly approved by

the party responsible for compliance. Such modifications could void the user’s authority to

operate the equipment.

15.105(b)

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular