User's Manual

INDOOR HOTSPOT User’s Manual V1.0

the heat dissipation.

Note

:If you want place your miner outside,please consider our IP67

rated weatherproof outdoor hotspot miner.

Preparing Indoor Hotspot

Please perform the following steps Before you use this hotspot:

 Step 1: First screw in the included antenna into the connector

on the back of the hotspot.

Figure 2: Install LoRa and GPS Antennas

 Step 2: Next find a suitable location for your Hotspot to be

positioned, to provide the best coverage we recommend placing

it near a window just out of direct sunlight. You’ll need to

be near a mains power source too.

 Step 3: Connect the LAN interface of the hotspot to the Ethernet

router or switch through a network cable.

Figure 3: Install the net cable

 Step 4: Select an appropriate connector according to the power