INDOOR HOTSPOT User’s Manual V1.
INDOOR HOTSPOT User’s Manual V1.0 Box Contents Your Indoor Hotspot comes with the following items： Figure 1: TL201 Indoor Hotspot Included Parts List： The TL201 Indoor Hotspot RP-SMA LoRa Antenna RP-SMA GPS Active Antenna Worldwide 12V 2A Power Adapter（With UK，US，EU and Aus plug heads） Please note the above image is for illustrative purposes only,colours of some parts may change.
INDOOR HOTSPOT User’s Manual V1.0 the heat dissipation. Note:If you want place your miner outside,please consider our IP67 rated weatherproof outdoor hotspot miner. Preparing Indoor Hotspot Please perform the following steps Before you use this hotspot: Step 1: First screw in the included antenna into the connector on the back of the hotspot.
INDOOR HOTSPOT User’s Manual V1.0 plug standard you are using, install the connector on the power adapter, and plug into a power socket to switch on the power. Figure 4: Select an appropriate adapter Step 5: Finally, connect the DC plug of the power adapter to the DC socket of the Hotspot. Figure 5: Connect the DC plug Step 6: You should see the RUN indicator light up on the front of the hotspot, which will now take about 6 minutes to configure for its first startup.
INDOOR HOTSPOT User’s Manual V1.0 Configuring Indoor Hotspot To configure your Hotspot, you will require the Helium Network application installed on a Mobile Phone, and for you to have gone through the account setup process to continue. Prerequisites： Ready to connect the hotspot Helium application with account Operating Steps： Step 1: Open the Helium application and login, then press + Add a Hotspot. Step 2: Next click Set up Hotspot, from here you will want to select Indoor Hotspot.
INDOOR HOTSPOT User’s Manual V1.0 Parameter Specification Parameter Symbol Conditions Min Typical Max Units AC power adapter Input Voltage ACin 100 240 VAC Input Frequency Fin 47 63 Hz Output Voltage VDCout Rated Output Load IDCout 12 VDC 2 ADC 2480 MHz -5.44 dBm 914.9 MHz 23.19 dBm 927.5 MHz 27.
INDOOR HOTSPOT User’s Manual V1.0 FCC Statement Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
