Safety Information

Contact the vendor.
Contact the vendor.
Meter does not enter the test mode after inserting a test strip.
Probable Cause
What to Do
The battery is dead.
Replace the battery (and reset the date and
time,if necessary.)
The battery is installed
incorrectly or there is no
battery in the meter.
Check that the battery is installed correctly
with the positive(+)sign facing upward,
toward you.
Test strip inserted upside
down, or
incompletely inserted
into the meter.
Insert the test strip with the
printed side up
Defective meter or test strips.
Contact the vendor.
Blood or foreign objects put
into the test strip port.
Test does not start after applying the blood sample.
Probable Cause
What to Do
Defective test strip.
Repeat the test with a new test strip.
Sample applied after meter
times out and
turns off.
Defective meter or test strips.
Troubleshooting
meter.
and the top of the strip in the
38
Remove the test strip, and repeat the test using
test strip symbols on the display screen before
a new test strip. Wait until you see the blood and
you apply the blood sample.