User's Manual
Table Of Contents
- 1 Overview
- 2 Appearance
- 3 Typical Application
- 4 Terminals and Interfaces of Wiring
- 5 Installation and Wiring
- 6 Before You Start
- 7 Video Intercom Device Set-up Tool
- 8 Batch Configuration Tool
- 9 Setting the Door Station via iVMS-4200
- 10 Local Operation
- Appendix
Video Intercom Door Station
·User Manual
40
Figure 8-33 Calling Buttons Interface
2. Select the button number.
3. Enter the floor No. and the room No..
4. Click the Apply button to enable the settings.
For DS-KV8102-IM, DS-KV8102-IP, and DS-KV8102-VP, there is no need setting the Room
No..
8.4.3 Network
Local Network Configuration
Steps:
1. Click the Local Network Configuration button to enter the local network
configuration interface.
Figure 8-34 Local Network Configuration Interface
2. Enter the local IP address, subnet mask, gateway address, and port No..
3. Click the Apply button to enable the settings.
The default port No. is 8000.
After editing the local network parameters of device, you should add the devices to
the device list again.