User's Manual
Table Of Contents
- 1 Overview
- 2 Appearance
- 3 Typical Application
- 4 Terminals and Interfaces of Wiring
- 5 Installation and Wiring
- 6 Before You Start
- 7 Video Intercom Device Set-up Tool
- 8 Batch Configuration Tool
- 9 Setting the Door Station via iVMS-4200
- 10 Local Operation
- Appendix
Video Intercom Door Station
·User Manual
38
Access Control and Elevator
1. Click the Access Control and Elevator button to enter password changing interface.
Figure 8-30 Access Control and Elevator Settings Interface
2. Set corresponding parameters on the access control and elevator settings interface.
Access Control
1) Select the door No..
2) Set the door-unlocked duration.
3) Click the Apply button to enable the settings.
Elevator Control
1) Select the elevator No., interface, RS485 protocol.
2) Select Yes/No of the elevator linkage.
3) Enter the server IP address and server port No..
4) Click the Apply button to enable the settings.
The doorphone does not support the elevator control function.
I/O Input and Output
Steps:
1. Click the I/O Input and Output button to enter the I/O input and output interface.