User's Manual
Table Of Contents
- 1 Overview
- 2 Appearance
- 3 Typical Application
- 4 Terminals and Interfaces of Wiring
- 5 Installation and Wiring
- 6 Before You Start
- 7 Video Intercom Device Set-up Tool
- 8 Batch Configuration Tool
- 9 Setting the Door Station via iVMS-4200
- 10 Local Operation
- Appendix
Video Intercom Door Station
·User Manual
26
When the device is not activated, the basic operation and remote operation of device
cannot be performed.
8.2 Editing Network Parameters
Purpose:
You can edit the network parameters of online devices.
Steps:
1. Select an online device in the online devices list in the lower part of the batch
configuration software interface.
2. Click the Edit NET Parameters button.
Figure 8-2 Edit NET Parameters
3. Enter a new IP address, subnet mask, gateway address, port No. and the password.
4. Click the OK button to accomplish the editing.
Figure 8-3 Edit Network Parameters
The default port No. is 8000.
After editing the network parameters of device, you should add the devices to the
device list again.
When you edit network parameters remotely, the device should be in the same
network segment.