User's Manual

Table Of Contents
Congure Parameters for Lane Controller
Aer adding the lane controller to the client, you can congure its parameters for passing through
the lane.
Steps
1. Click Access Control → Advanced Funcon → Device Parameter to enter Parameter Sengs
page.
2. In the device list on the le, select a lane controller and you can edit the lane controller's
parameters on the right.
3. Edit the parameters.
Passing Mode
Select the controller which will control the barrier status of the device.
If you select According to DIP Sengs, the device will follow the device's DIP sengs to
control the barrier. The sengs on the soware will be invalid.
If you select According to Door's Schedule Sengs, the device will follow the schedule
sengs of the soware to control the barrier. The DIP sengs of the device will be invalid.
Audible Prompt Duraon
Set how long the audio will last, which is played when an alarm is triggered .
Note
0 refers to the alarm audio will be played unl the alarm is ended.
Temperature Unit
Select the t
emperature unit that displayed in the device status.
Lightboard Brightness
Set the strip light brightness.
4. Click OK.
6.7.2 Congure Remaining Open/Closed
You can set the status of the door as open or closed. For example, you can set the door remaining
closed in the holida
y, and set the door remaining open in the specied period of the work day.
Before You Start
Add the access control devices to the system.
Steps
1. Click Access Control → Advanced
Funcon → Remain Open/Closed to enter the Remain Open/
Closed page.
2. Select the door that need to be congured on the le panel.
DS-K3G501 Series Tripod Turnsle User Manual
59