User's Manual

Table Of Contents
Note
Enter the person's basic informaon rst. For details about conguring person's basic
informaon, refer to Congure Basic Informaon .
3. In the
Credenal → Fingerprint panel, click +.
4. In the pop-up window, select the collecon mode as Local.
5. Select the model of the connected ngerprint recorder.
Note
If the
ngerprint recorder is DS-K1F800-F, you can click Sengs to select the COM the
ngerprint recorder connects to.
6. Collect the ngerprint.
1) Click St
art.
2) Place and li your ngerprint on the ngerprint recorder to collect the ngerprint.
3) Click Add to save the recorded ngerprint.
7. Conrm to add the person.
-
Click Add to add the person and close the Add Person window.
-
Click Add and New to add the person and connue to add other persons.
Note
Once the
ngerprint is added, the ngerprint type cannot be changed.
6.4.8 Congure Access Control Informaon
When adding a person, you can set her/his access control properes, such as seng the person as
a visit
or or a blacklist person, or as a super user who has super authorizaon.
Steps
1. En
ter Person module.
2. Select an organizaon in the organizaon list to add the person and click Add.
3. In the Access Control area, set the person's access control properes.
Access Group
Y
ou can select one or more access groups for the person to give him/her the authorizaon to
the selected access points. For details, refer to Set Access Group to Assign Access
Authorizaon to Persons .
P
assword
The person must enter the password aer swiping the card or ngerprint when accessing. It
cannot be used independently and should contain 4 to 8 digits.
Super User
DS-K3G501 Series Tripod Turnsle User Manual
42