User's Manual

Table Of Contents
Note
The cable bare part should be no more than 8 mm. If possible, wear an insulaon cap at the end
of the bar
e cable. Make sure there’s no bare copper or cable aer the wiring.
The Terminal L and the Terminal N cannot be wired reversely. Do not wire the input and output
terminal reversely.
To avoid people injury and device damage, when tesng, the ground resistance of the
equipotenal points should not be larger than 2 Ω
3.3 General Wiring
The picture displayed below describes the interconnecng cable's wiring diagram.
DS-K3G501 Series Tripod Turnsle User Manual
7