Quick Start Guide
Table Of Contents
- Legal Information
- Regulatory Information
- Safety Instruction
- Available Models
- Chapter 1 Overview
- Chapter 2 Wiring
- 2.1 Components Introduction
- 2.2 Wiring Electric Supply
- 2.3 Wire Interconnecting Cable
- 2.4 Terminal Description
- 2.4.1 Master Control Board Terminal Description
- 2.4.2 Slave Control Board Terminal Description
- 2.4.3 Main Control Board Terminal Description
- 2.4.4 Main Control Board Serial Port ID Description
- 2.4.5 RS-485 Wiring
- 2.4.6 RS-232 Wiring
- 2.4.7 Wiegand Wiring
- 2.4.8 Barrier Control Wiring
- 2.4.9 Alarm Output Wiring
- 2.4.10 Fire Alarm Module Wiring
- Chapter 3 Installation
- Chapter 4 Device Settings
- Chapter 5 Activation
- Appendix A. Tips for Scanning Fingerprint
- Appendix B. DIP Switch
- Appendix C. Event and Alarm Type
- Appendix D. Table of Audio Index Related Content
- Appendix E. Error Code Description
- Appendix F. Communication Matrix and Device Command
UART4
The serial port is in the wiring interface according to the picture above, which has a xed RS-232
communicaon mode to communicate with the master lane controller. It contains no jumper
c
ap and cannot change the communicaon mode.
UART7/UART8
Reserved serial port. The serial port has a xed RS-232 communicaon mode. It contains no
jumper c
ap and cannot change the communicaon mode. It can connect QR code scanner, card
recycler, and text screen.
The reserved interface posions in the turnsle and their corresponded UART No. are as follows:
Figure 2-7 Interface and Corresponded UART No.
DS-K3B501S Series Swing Barrier Quick Start Guide
13