Quick Start Guide

Figure 2-5 Face
Recognion Terminal Wiring
Note
• The supplied interconnecng cable length is 3.75 m. If you need a longer one, ask our technique
supports or sales and pur
chase 5.5 m interconnecng cables.
• The suggested inner diameter of the low voltage conduit is larger than 30 mm.
• If you want to bury both of the AC power cord and the low voltage cable at the entrance side,
the two cables should be in separated conduits to avoid interference.
• If more peripherals are required to connect, you should increase the conduit diameter or bury
another conduit for the external cable.
• The external AC power cord should be double-insulated.
• The suggested network cable should be CAT5e or the network cable has beer performance.
And the suggested network cable length should be less than 100 m.
2.4 Terminal
Descripon
The lane controller contains master lane controller and slave lane controller, which controls the IR
beams, motor, and other components' work.
2.4.1 Master Control Board Terminal Descripon
The master lane control board contains interconnecng interfaces, BUS, motor encoder interface,
debug
ging port, door closed posion interface, seven-segment display, strip light interface
(reserved), supercapacitor, power interface, motor drive interface, and DIP switch.
The picture displayed below is the master control board diagram.
DS-K3B501S Series Swing Barrier Quick Start Guide
7