Quick Start Guide

Network PTZ Camera·Quick Start Guide
vii
 Do not connect several devices to one power adapter as adapter
overload may cause over-heating or a fire hazard.
 Make sure that the plug is firmly connected to the power socket.
 Make sure that the power has been disconnected before you wire,
install or dismantle the PTZ camera.
 When the product is mounted on wall or ceiling, the device shall
be firmly fixed.
 If smoke, odor or noise rise from the device, turn off the power at
once and unplug the power cable, and then contact the service
center.
 If the product does not work properly, contact your dealer or the
nearest service center. Never attempt to disassemble the camera
yourself. (We shall not assume any responsibility for problems
caused by unauthorized repair or maintenance.)
Cautions
 If the camera fails to synchronize local time with that of the
network, you need to set up camera time manually. Visit the
camera (via web browser or client software) and enter system
settings interface for time settings.
 Make sure the power supply voltage is correct before using the
camera.
 Do not drop the camera or subject it to physical shock, and do not
expose it to high electromagnetism radiation. Avoid installation on
vibrations surface or places subject to shock (ignorance can cause
device damage).