Quick Start Guide

Network PTZ Camera·Quick Start Guide
35
3. Connect the cables and route the cable through the cable hole.
Note:
Water-proof treatment is required for cable connectors. Refer to
section 2.9 and 2.10 for details.
4. Align the PTZ camera with the base plate. Rotate the PTZ camera
clockwise into the base plate, and the PTZ camera is secured with
the base plate by three locks on the plate.
5. Fix the screws on the side with a screwdriver, as shown in Figure
2-49.
①
OPEN LOCK
②
③
Figure 2-52 Fix the Camera
6. Fix the decorative rim with the bubble and the decorative rim will
be attached to the in-ceiling bracket automatically, as shown in
Figure 2-50.