User's Manual

AX PRO User Manual
37
Arm/Disarm the Area
Arm or disarm the area manually as you desired.
On the device list page, tap the AX PRO and then log in to the device (if required) to enter the Area
page.
Operations for a Single Area
● Away Arming: Tap any area to away arm a single area. When all the people in the detection
area leave, turn on the Away mode to arm all zones in the area after the defined dwell time.
● Disarm: Tap Away Arming Icon in any area to disarm a single area. In Disarm mode, all the
zones in the area will not trigger alarm, no matter alarm events happen or not.
Operations for All Areas
● Away: Tap Away Arming Icon to away arm all areas. When all the people in the detection area
leave, turn on the Away mode to arm all zones in all areas after the defined dwell time.
● Stay: Tap Stay Arming Icon to stay arm all areas. When the people stays inside the detection
area, turn on the Stay mode to arm all the perimeter burglary detection (such as perimeter
detector, magnetic contacts, curtain detector in the balcony) set in all the zones of all areas. At
the meantime, the detectors inside the detection area are bypassed (such as PIR detectors).
People can move inside the area and alarm will not be triggered.
● Disarm: Tap Disarm Icon to disarm all areas. In Disarm mode, all the zones of all areas will not
trigger alarm, no matter alarm events happen or not.
● Clear Alarm: Tap Clear Alarm Icon to clear alarms for all areas. Clear all the alarms triggered by
the all the zones of all the areas.
Check Alarm Notification
When an alarm is triggered, and you will receive an alarm notification. You can check the alarm
information from the mobile client.
Before You Start
● Make sure you have linked a zone with a detector.
● Make sure the zone is not bypassed.
● Make sure you have not enabled the silent zone function.
Steps
1. Tap Notification in the mobile client to enter the page.