User's Manual

AX PRO User Manual

sounder can be enrolled to the hybrid AX PRO via the wireless receiver that is at the address of 9.

Steps

1. In the site, tap the AX PRO and then log in to the device (if required).

2. Tap a sounder in the Device tab.

3. Tap .

4. Tap Edit Icon the sounder name.

5. Select linked areas.

6. Set alarming lasting time and alarm volume.

7. Enable arming/disarming LED, arming/disarming buzzer, alarm indicator according to actual

needs.

8. Set heartbeat cycle.

9. Optional: Tap Delete to delete the device.

4.1.2 User the Hik-ProConnect Portal

For AX Pro security control panel, you can perform operations including arming/disarming area,

clearing alarm, bypassing zone etc., and remotely configure the control panel on the Portal. You

can also apply for PIN (required for upgrading the firmware of AX Pro) and switch the language of

AX Pro.

Click Site to enter the site list page, and then click the name of a site to enter site details page.

Remotely Operate AX Pro

Click the AX Pro to open the operation panel. And you can perform the following operations.

Table 4-3 Operation Description

Operation

Description

Stay Arm a Specific Area

Select the Area tab, and then click Stay Arming to stay arm the

area.

Away Arm a Specific Area

Select the Area tab and then click Away Arming.

Disarm a Specific Area

Select the Area tab and then click Disarm.

Stay Arm Multiple Areas

Select the Area tab, and then select areas and click .

Away Arm Multiple Areas

Select the Area tab, and then select areas and click .

Disarm Multiple Areas

Select the Area tab, and then select areas and click .

Clear Alarms of Multiple

Areas

Select the Area tab, and then select areas and click

Filter Peripheral Device by

Area

Select the Device tab, and then click and select an area to

only display the peripheral devices linked to the selected area, or

select All to display all the peripheral devices linked to all the

areas.