User's Manual

AX PRO User Manual
23
2. Tap → IPC → Event Video Settings to enter the page.
3. Select a camera and set the video parameters.
Stream Type
Main Stream: Being used in recording and HD preview, it has a high resolution, code rate and
picture quality.
Sub-Stream: It is used to transmit network and preview pictures as a video streaming with
features of lower resolution, bit rate and picture quality.
Bitrate Type
Select the Bitrate type as constant or variable.
Resolution
Select the resolution of the video output.
Video Bitrate
The higher value corresponds to the higher video quality, but the better bandwidth is
required.
Set Arming/Disarming Schedule
Set the arming/disarming schedule to arm/disarm a particular zone automatically.
In the site, tap the AX PRO and then log in to the device (if required).
Tap → Area to enter the page.
Tap an area in the list, enable the area and select linked zones.
Enable the auto arm/disarm function and set the auto arm time/auto disarm time. You can also
set the late to disarm time, entry delay time, exit delay time, sounder delay time, weekend
exception and excepted holiday.
Auto Arm
Enable the area to automatically arm itself in a specific time point.
Auto Arm Time
Set the schedule for the area to automatically arm itself.
Late to Disarm
Enable the device to push a notification to the phone or tablet to remind the user to disarm the
area when the area is still armed after a specific time point.
Note
You should enable the Panel Management Notification function on the Web Client of
Communication Parameters → Event Communication before enabling the Late to Disarm
function.