User's Manual

AX PRO User Manual
22
Arming Indicator Keeps Light
If the device applies EN standard, by default, the function is disabled. In this case, if the device is
armed, the indicator will be solid blue for 5 s. And if the device is disarmed, the indicator will
flash 5 times.
When the function is enabled, if the device is armed, the indicator will be on all the time. And if
the device is disarmed, the indicator will be off.
Prompt Fault When Arming
If the device applies EN standard, by default, the function is disabled. In this case, the device will
not prompt faults during the arming procedure.
Early Alarm
If you enable the function, when the zone is armed and the zone is triggered, the alarm will be
triggered after the delay time.
Delay Time
When the early alarm function is enabled, you should set the delay time. The alarm will be
triggered after the configured delay time.
Enrollment Method
In the site, tap the AX PRO and then log in to the device (if required). Tap → System →
System Options → Enrollment Method to enter the page.
Tap Enter the Enrollment Mode.
Follow the instructions on the page to add a device.
Tap Exit the Enrollment Mode.
Network Camera
Add Cameras to the AX PRO
Steps
1. In the site, tap the AX PRO and then log in to the device (if required).
2. Tap → IPC → IPC management to enter the page.
3. Tap Add.
4. Enter IP address, port, the user name and password of the camera.
5. Tap Save Icon.
6. Optional: tap Edit or Delete to edit or delete the selected camera.
Set Video Parameters
Steps
1. In the site, tap the AX PRO and then log in to the device (if required).