Quick Start Guide

Radar PTZ Camera·Quick Start Guide
v
device is intended for installation in a restricted access location, access can only be
gained by service persons or by users who have been instructed about the reasons for
the restrictions applied to the location and about any precautions that shall be taken.
 The high beam of IR supplement light at the distance of 200 mm is classified as Risk
Group 1 (RG1). The white alarm light in solid mode is classified as Risk Group 2 (RG2).
The minimum safe distance is approximately 1.5 m away from the device.
 Possibly hazardous optical radiation emitted from this product may be harmful to the
eyes. Do not stare at operating light source.
 If appropriate shielding or eye protection is not available, turn on the light only at a
safe distance or in the area that is not directly exposed to the light when installing or
maintaining the device.
 If the speed dome fails to synchronize local time with that of the network, you need
to set up speed dome time manually. Visit the speed dome (via web browser or client
software) and enter system settings interface for time settings.
 Make sure the power supply voltage is correct before using the speed dome.
 Do not drop the speed dome or subject it to physical shock, and do not expose it to
high electromagnetism radiation. Avoid installation on vibrations surface or places
subject to shock (ignorance can cause device damage).
 Do not touch senor modules with fingers. If cleaning is necessary, use clean cloth with
a bit of ethanol and wipe it gently. If the speed dome will not be used for an extended
period, replace the lens cap to protect the sensor from dirt.
 Do not aim the speed dome at the sun or extra bright places. Blooming or smearing
may occur otherwise (which is not a malfunction), and affect the endurance of sensor
at the same time.
 The sensor may be burned out by a laser beam, so when any laser equipment is in
using, make sure that the surface of sensor will not be exposed to the laser beam.
 Do not place the speed dome in extremely hot (the operating temperature shall be
-40°C to 70°C (-40°F to 158°F)), cold, dusty or damp locations, and do not expose it to
high electromagnetic radiation.
 To avoid heat accumulation, good ventilation is required for operating environment.
 Keep the speed dome away from liquid while in use.
 While in delivery, the speed dome shall be packed in its original packing, or packing of
the same texture.
 This equipment is not suitable for use in locations where children are likely to be
present.
 CAUTION: Risk of explosion if the battery is replaced by an incorrect type. Dispose of
used batteries according to the instructions
ATTENTION: IL Y A RISQUE D'EXPLOSION SI LA BATTERIE EST REMPLACÉE PAR UNE
BATTERIE DE TYPE INCORRECT. METTRE AU REBUT LES BATTERIES USAGÉES
CONFORMÉMENT AUX INSTRUCTIONS
 Do not dispose of the battery into fire or a hot oven, or mechanically crush or cut the
battery, which may result in an explosion.