Quick Start Guide

Radar PTZ Camera·Quick Start Guide
4
 For cement wall, you need to use the expansion screw to fix the bracket. The
mounting hole of the expansion pipe on the wall should align with the mounting
hole on the bracket.
 For wooden wall, you can just use the self-tapping screw to fix the bracket.
 Make sure that the wall is strong enough to withstand more than eight times the
weight of the speed dome and the accessories.
 Water-proof treatment is required for cable connectors. Refer to Section 2.3 and 2.4
for details.
Steps:
1. Install the bracket.
1) Drill four screw holes in the wall according to the holes on the bracket, and
then insert four expansion screws into the mounting holes.
2) Attach the bracket to the wall by aligning the four screw holes on the bracket
with four expansion screws on the wall.
3) Secure the bracket with four sets of hex nuts and washers.
Figure 2-2 Install the Bracket
2. Use the wrench to fix head cover on the bracket.
Note:
Make sure the radar module is directly face to the moving target.