User's Manual

OEM Installation Guide:

This device is intended only form OEM integrators under the following conditions:

1) The antenna must be installed such that 20cm is maintained between the

antenna and users, and

2) The transmitter module may not be co-located with any other transmitter or

antenna.

IMPORTANT NOTE: In the event that these conditions can not be met (for example

certain laptop configurations or co-location with another transmitter), then the FCC

authorization is no longer considered valid and the FCC ID can not be used on the

final product. In these circumstances, the OEM integrator will be responsible for

re-evaluating the end product (including the transmitter) and obtaining a separate

FCC authorization.

15.21 Regulatory information:

Installation and use of this Wireless LAN device must be in strict accordance with the

instructions included in the user documentation provided with the product. Any

changes or modifications (including the antennas) made to this device that are not

expressly approved by the manufacturer may void the user’s authority to operate the

equipment. The manufacturer is not responsible for any radio or television

interference caused by unauthorized modification of this device, or the substitution of

the connecting cables and equipment other than manufacturer specified. It is the

responsibility of the user to correct any interference caused by such unauthorized

modification, substitution or attachment. Manufacturer and its authorized resellers or

distributors will assume no liability for any damage or violation of government

regulations arising from failing to comply with these guidelines.

15.199a)(3)

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference.

This device must accept any interference received, including interference that may

cause undesired operation.

15.105 FCC Reuqirements:

This equipment has been tested and found to comply with the limits for a class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that