User's Manual

Quick Start
H3C WA2110-AG Wireless LAN Access Point
Chapter 2
Installation
2-6
I. Wall, Ceiling Mounting
To mount the access point to a wall, follow the given steps below:
1) Remove the access point from the mounting bracket.
2) Route the power cable (if you use an external power supply)
and Ethernet cable on the back of the mounting bracket, as
shown in
Figure 2-3.
Caution:
For easy installation and removal of the access point from the
mounting bracket, make sure that there is sufficient flexibility with the
cable and that the cable is long enough. If not enough cable is routed
through the back of the mounting bracket, or if the cable is inflexible, it
can be difficult to install or remove the access point from the mounting
bracket.
Figure 2-3 Cabling on the back