User's Manual

Quick Start
H3C WA2110-AG Wireless LAN Access Point
Chapter 2
Installation
2-5
z Electric screwdriver and Phillips screwdriver
z One electric drill and several auxiliary drill bits
2.3.2 Checking the Device Before Installation
Before mounting the H3C WA2110-AG, connect it to the power
supply (if applicable) and an Ethernet, and check the status of LEDs to
ensure that the H3C WA2110-AG can work properly. In addition,
record the MAC address of the access point for future use.
2.3.3 Attaching the Antennas
Screw the antennas on to the antenna connectors on the access
point and hand-tighten them. After network startup, you may need to
adjust the antennas to fine-tune coverage in your area. For best
results, adjust the antennas so that they are perpendicular with the
floor or ceiling.
Caution:
Do not handle the antenna tips, especially after they are connected to
the access point. This could lead to electrostatic discharge (ESD),
which could damage the equipment.
2.3.4 Mounting the Access Point
The access point can be mounted on walls, ceilings or tabletops.