User's Manual

Hangzhou H3C Technologies Co., Ltd.
2008-12-12 4
For laptop installations, the antenna must be installed to ensure that the proper spacing is
maintained in the event the users places the device in their lap during use (i.e. positioning of
antennas must be placed in the upper portion of the LCD panel only to ensure 20 cm will be
maintained if the user places the device in their lap for use) and The transmitter module may
not be co-located with any other transmitter or antenna. As long as the 2 conditions above are
met, further transmitter testing will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for example, digital
device emissions, PC peripheral requirements, etc.).
NOTE: In the event that these conditions can not be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC authorization is no
longer considered valid and the FCC ID can not be used on the final product.
In these circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in devices where the antenna may be
installed such that 20 cm may be maintained between the antenna and users (for example
access points, routers, wireless ASDL modems, certain laptop configurations, and similar
equipment). The final end product must be labeled in a visible area with the following:
"
Contains TX FCC ID:U6I-EWPA1PICAA ".
RF Exposure Manual Information That Must be Included
The users manual for end users must include the following information in a prominent
location
NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for
this transmitter must be installed to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operating in conjunction with any other antenna or
transmitter."
Additional Information That Must be Provided to OEM Integrators
The end user should NOT be provided any instructions on how to remove or install the device.
Service Center in U.S.A
Company Name : H3C USA Co., Ltd
Company Address: 2301 N. Greenville Ave Suite 200, Richardson, Texas, USA 75082