EN ES FR UD
COPYRIGHT ©2017 Hangzhou Hikvision Digital Technology Co., Ltd. or its subsidiaries. ALL RIGHTS RESERVED. About this Manual The Manual includes instructions for using and managing the product. Pictures, charts, images and all other information hereinafter are for description and explanation only. The information contained in the Manual is subject to change, ™ website without notice, due to firmware updates or other reasons. Please find the latest version in the (http://www.ezvizlife.com).
there will be no personal injury or property loss as a result. You are highly recommended to raise your vigilance and strengthen the safety awareness in the daily life. SURVEILLANCE LAWS VARY BY JURISDICTION. PLEASE CHECK ALL RELEVANT LAWS IN YOUR JURISDICTION BEFORE USING THIS PRODUCT IN ORDER TO ENSURE THAT YOUR USE CONFORMS TO THE APPLICABLE LAW.
lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Operation The mini trooper should be used together with the base station. You need to purchase a base station separately. Step 1 Power-on 1. Insert batteries into the camera - Release the lock catch to open the battery cover of the camera. - Insert four batteries according to the figure below or insert two batteries to power on the camera (For two batteries installation, refer to the appendix). Battery Cover Lock Catch CR123 Battery - Cover the batteries and the LED indicator turns red for 3s. 2.
LED Indicator Step 2 Base Station Wi-Fi Setup • Option 1 (Recommended) Wi-Fi Connection via Relay Access 1. Connect to the Wi-Fi of base station - Connect your mobile phone or laptop to Wi-Fi named ezviz_XXXXXX (XXXXXX stands for last six numbers of base station MAC address). - Enter the Wi-Fi password (the default password is last four numbers of Serial Number and Verification Code). - Adjust the antennas according to the pop-up wizard.
• Option 2 Wi-Fi Connection via Wired Router/Network Interface 1. Cable connection - Connect the base station and the uplink router with network cable. 2. Connect to the Wi-Fi of base station - Connect your mobile phone or laptop to Wi-Fi named ezviz_XXXXXX (XXXXXX stands for last six numbers of base station MAC address). - Enter the Wi-Fi password (the default password is last four numbers of Serial Number and Verification Code). - Adjust the antennas according to the pop-up wizard.
2. In the synchronization interface, press the SYNC button on the camera for 6s. 3. Tap Sync button on your phone/laptop. Make sure the camera is close enough to the base station, or the connection between camera and base station may fails.
The typical application of the mini trooper system is shown below.
Appendix Mini Trooper SYNC Button Lens Microphone Photoresistance LED Indicator PIR Name Description SYNC Button Hold the SYNC button to synchronize the camera with the base station. PIR With the PIR (Passive Infrared), the device detects human body to judge whether anyone breaks in, and starts to record. • Steady Red: The camera is starting. • Slow Blue Flash: The camera starts to synchronize or the device is upgrading. • Fast Blue Flash: The synchronization finished.
Base Station Antenna Main Button LED Indicator Network Indicator Network Interface Reset Button Power Input Name Description Antenna The antennas enhance the quality of wireless network signal transmission between the base station and camera(s) or other wireless network terminals. • Steady Green: The system works properly. • Flashes Blue: Memory card is formatting or device starting synchronization with mini trooper. • Steady Red: Memory card does not exist, or exception occurs.
Box Content Quick Start Guide (x1) Mini Trooper (x1) Battery (x2) Screw Kit Metal Plate (x1) Base Station (Within Bundle) Battery Installation The mini trooper can work with two batteries (Model: CR123). Insert two batteries in the same side and the camera works properly, see figure below.
