User's Manual

9
1. NoteSerialNumberandVericationCode
-Writedowntheserialnumberandvericationcodelocatedonthe
base station.
2. Connect to the base station Wi-Fi.
In your mobile device, look for the Wi-Fi Network named “ezviz_xxxxxx”
(xxxxxx stands for the six digit combination after “ezviz_”)
- Once you choose the “ezviz_xxxxxx” network, enter the Wi-Fi
password which is the last four digits of the Serial Number + the
VericationCode,(listedonthedeviceandpackagelabel)
If the wizard does not pop up, access the IP address (192.168.7.1) in
your Web browser.
3. Wireless Relay Gateway Setup (connecting the base station to
your local Wi-Fi network):
-
In your mobile device press the “Start Button.”
- Adjust antenna on the base station. Once that is complete, click
the “Antenna adjusted” button.
- Follow the prompt to create a login password for the base station.
- Choose your preferred Time Zone and select Daylight Savings
Time (DST) On or Off.
- Choose the “Wi-Fi Relay Internet Access”
option as your connection mode.
- Search for and choose your local Wi-Fi network and enter your Wi-
Fi password. Press “Connect to Network.”
- Check your Base Station Wi-Fi settings. Note: You can change you
Base Station Wi-Fi Name and Password to your own preference.
- Press the “Save” button to save Wi-Fi settings.the LED indicator
on the Base Station will become from blue to steady green when
Internet is connected successfully.
- Proceed to Step 5 above through to Camera Installation.
Connect Base Station to Internet via Wi-Fi
(Optional)