Installation Instructions

— 6 —
Installation
Cheego Baby Monitor supports two installations: Clip-on Mounting and Floor Stand
Mounting. Please watch the installation video before you start install it.
1) Clip-on Mounting

The device is with Temperature Measurement function, so you need to choose one
position from below three positions to install.

Use the Allen wrench and M8*25 Screw to connect the camera and the clip bracket,
then to fix the baby monitor to the selected position on the crib and tighten the screw.
2) Floor Stand Mounting

The device is with Temperature Measurement function, so you need to put the floor
stand mounting on one position from below three positions.

Screw up the two aluminum rods, and tighten it with the counterweight plate, then
connect the camera with the fixed aluminum rod.
Notes:

The actual installation position must stay the same with the virtual installation position
in your Cheego Smart Application.

And please check if the camera could capture baby's facial image in your Cheego
Smart APP after the installation and setting. If not, please adjust the installation
position or angle.