Installation Instructions

— 3 —
Safety and RF Statement
⚠ WARNING: Strangulation Hazard—Children have STRANGLED in cords. NEVER
attempt to use cord without the protective covering. Check protective covering before
each use to ensure that the cord is not exposed to your child. Immediately discontinue use
if protective covering is damaged or broken.

This device is designed to be used on or next to a standard crib, in the middle of the
long side of the crib.

Adult assembly is required. Keep small parts away from children when assembling.

This product cannot replace adult supervision. Ensure your child’s health by checking
on him/her regularly.

This device is designed for indoor use only.

This product and its packaging are not toys. Do not allow children to play with them.

Falling warning---In order to prevent products fell to hurt, be sure to install the monitor
in a stable location, tighten the screws and tighten button, securely monitor your
device.

Make sure the virtual installation position in Cheego Smart Application is same to the
actual installation position in the crib. And make sure the camera could capture the
baby’s facial image clearly after the installation.

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with