Specifications

- 15 -
(1) Operational use conditions
***if your module has professional users use condition limitations, please keep
below sentence here Module has professional users use condition limitations,
Host product manufacturer please ensure giving such warning like “Product is
limited to professional users use” in your product’s instruction.
(2) Antenna used
Antenna Type
Brand/ manufacturer
Model No.
Max. Antenna Gain
PCB Hangzhou
BroadLink
Technology Co.,Ltd
/ 2dBi
(3) Notice to Host Product Manufacturer
Any deviation(s) from the defined parameters of the antenna trace, as described
by this instruction, host product manufacturer must notify us that you wish to
change the antenna trace design. In this case, a Class II permissive change
application is required to be filed by us, or you (host manufacturer) can take
responsibility through the change in FCC ID and IC ID (new application)
procedure followed by a Class II permissive change application.
(4) Labelling Instruction for Host Product Integrator
Please notice that if the FCC and IC identification number is not visible when the
module is installed inside another device, then the outside of the device into
which the module is installed must also display a label referring to the enclosed
module. This exterior label can use wording such as the following:
“Contains FCC ID: 2ATEV-BL3385-P” and “Contains IC: 25062-BL3385P” any
similar wording that expresses the same meaning may be used.
§ 15.19 and RSS-Gen Labelling requirements shall be complied on end user
device. Labelling rules for special device, please refer to §2.925, § 15.19 (a)(5)
and relevant KDB publications. For E-label, please refer to §2.935.
(5) Installation Notice to Host Product Manufacturer
The OEM integrator is responsible for ensuring that the end-user has no
manual instruction to remove or install module.
The module is limited to installation in mobile application, a separate
approval is required for all other operating configurations, including portable
configurations with respect to §2.1093 and difference antenna configurations.
(6) Antenna Change Notice to Host manufacturer
If you desire to increase antenna gain and either change antenna type or use
same antenna type certified, a Class II permissive change application is required
to be filed by us, or you (host manufacturer) can take responsibility through the
change in FCC ID and IC ID (new application) procedure followed by a Class II
permissive change application.
(7) FCC other Parts, Part 15B Compliance Requirements for Host product manufacturer
This modular transmitter is only FCC authorized for the specific rule parts listed
on our grant, host product manufacturer is responsible for compliance to any