Users Manual

Frequently Asked Questions
Fault Solutions
The nozzle leaks or the outlet
pressure suddenly increases
Water came out after the machine
was shut down
Foam pot can't spray detergent
The machine can't suck water by
itself or lack of pressure
The new machine won't start or
stop automatically
The nozzle is blocked. Please clean the blockage or
replace the nozzle before using it
After the machine is shut down, there is water residue in the
pump door, and the water is completely discharged before
The foam pot is blocked and cleaned with water
(1) If the machine is too high from the water source surface, lower the machine
to less than 1.5 meters from the water source surface
(2) If the water tube filter is blocked, take out the water tube filter and clean up
the sundries with water
(3) If the self-provided water tube is not well combined with the machine, check
and reinstall the water tube
(4) The tube joint is loose and the tube is not in place
(5) Pumps, water tubes or other accessories are frozen and reused after thawing
(1) Please check whether the Power Battery is installed in place. If there is no
electricity or it is broken, please charge or replace it with a new Power Battery
(2) The motor overheating device will automatically cut off power protection
according to the temperature and voltage of the internal motor