Operating Guide

HANGPRO DRYWALL LIFT
ASSEMBLY INSTRUCTIONS
Step 6
At the top of the main frame, loosen the nut that holds the pulley and cable keeper. Do not remove
the bolt. Lift the cable keeper off and thread cable over the top of the pulley so the cable is resting
in the middle of the pulley. Unwind all cable from winch and pull cable down the front of the lift.
Thread cable between the main frame and the cradle as shown in Figure J.
Using one M8x20mm bolt attach cable loop to the cradle as shown in Figure K. Remove clamp
from lower main frame. Reinstall cable keeper as shown in Figure I.
Figure I
Figure I shows
properly installed
cable and cable
keeper.
Figure J
Figure J shows
proper cable
routing on the front
side of lift (cable
travels between
main frame and
cradle).
Figure K
Attach cable loop
to lower cradle.
Now your HangPro Drywall Lift is ready
to start hanging drywall the easy way！
Page 7