Operating Guide

HANGPRO DRYWALL LIFT
ASSEMBLY INSTRUCTIONS
Step 1
Lay the two halves of the cradle
on a flat surface.
Attach halves together by using
four M8X35mm bolt and nuts as
shown in Figure A but do not
tighten the nuts. Place the two
wheels on a flat surface and lay
cradle on top of the wheels with
the ledges facing down. Press
down on the outside edges of
the cradle sides until there is
slight movement.
Tighten the four nuts on the
cradle and set cradle aside.
Figure A
Step 2
With the long leg of the axle
frame on top, attach the two axle
frames to the roller frame.
Use two M8X20mm bolts and
nuts on the upper legs and four
M8X20mm bolts and nuts on the
lower legs.
Push the axle through the axle
frame. Attach wheels by using
pliers to insert the four cotter
keys as shown in Fig B.
Figure B
Step 3
Attach upper and lower
frames using one
M8X70mm bolt and nut
and two M8X20mm bolts
as shown in Figure C.
Figure C
Page 4