User Manual

Required Parts

• Fuselage • Plywood battery tray

• Hook and loop strap • Cowling

• 4-40 x 3/8" socket head screw (2)

• 6-32 x 1

" screw (4)

• 1" (25mm) aluminum motor spacer (4)

• Hook and loop (adhesive back)

• #2 x 1/2" sheet metal screw (2)

Required Tools and Adhesives

• Phillips screwdriver • Threadlock

• Hex wrench: 3/32" • Drill

• Male Deans connector (3) • Soldering iron

• Drill bit: 9/64" (3.5mm)

• Female Deans connector w/wire

• Solder

• 4200mAh 2S2P 7.4V Li-Po (2)

 Step 1

Enlarge the outer mounting holes in the X-mount of the

motor using a 9/64" (3.5mm) drill.

 Step 2

Attach the X-mount to the back of the motor using the

hardware provided with the motor. Remember to put a

drop of threadlock on each of the screws to prevent them

from vibrating loose.

 Step 3

Attach the motor to the firewall using the 1" (25mm)

spacers and 6-32 x 1

" screws. Use threadlock on the

screws here as well.

Section 7A: Electric Motor Installation