User Manual

22
  Step 9
Attach the 23
3
/
8
" (594mm) rudder pushrod to the servo
arm using the “Z” bend in the pushrod. You may need to
use a 5/64" (2mm) drill bit to enlarge the hole in the servo
arm to accept the wire.
  Step 10
Turn the radio system on and center the rudder stick and
rudder trim. Slide the pushrod wire into the pushrod
tube. Secure the servo arm to the servo using the screw
included with the servo.
  Step 11
Slide a clevis retainer onto a clevis. Thread the clevis onto
the rudder pushrod.
 Step 12
Repeat Steps 9 through 11 for the 22
1
/
2
" (572mm)
elevator pushrod wire.
Section 5: Servo Installation