User Manual

20
Required Parts
• Fuselage
• 23
3
/
8
" (594mm) rudder pushrod
• 22
1
/
2
" (572mm) elevator pushrod wire
• Clevis w/retainer
Required Tools and Adhesives
• Drill • Felt-tipped pen
• Switch harness • Standard servo (3)
• Phillips screwdriver
• Drill bit: 1/16" (1.5mm), 5/64" (2mm)
Note: The throttle servo is not required when
building the electric version of your Pulse XT.
  Step 1
If you choose to use a glow engine, place the throttle
servo into the fuselage. Use a felt-tipped pen to mark
the locations for the four servo mounting screws on
the radio tray.
  Step 2
Use a 1/16" (1.5mm) drill bit to drill the locations for the
screws. Place a drop of thin CA into each of the holes to
harden the surrounding wood.
  Step 3
Secure the throttle servo using the hardware supplied with
the servo. Don’t forget to install the grommets and brass
eyelets before installing the servo.
Section 5: Servo Installation