User Manual

19
  Step 7
Use a 9/64" (3.5mm) drill bit to drill the two locations
for the screws.
  Step 8
Install two 4-40 blind nuts inside the wheel pants through
the holes drilled in the previous step.
  Step 9
Secure the wheel pant to the landing gear using two
4-40 x 3/8" socket head screws. Make sure to use
threadlock to prevent the screws from loosening
during flight.
  Step 10
Check that the wheel can spin freely without rubbing on
the wheel pant. If it does, loosen the 4mm nut and 4mm
locknut and reposition the wheel so it can spin freely.
 Step 11
Repeat Steps 6 through 10 to install the remaining
wheel pant.
Section 4: Landing Gear Installation