User Manual

  Step 4

Position the inner 4mm nut so there is about 7/16"

(12mm) between the wheel nut and landing gear.

Tighten the 4mm locknut onto the screw. The

distance may require some adjustment once the

wheel pants have been installed.

 Step 5

Repeat Steps 2 through 4 for the remaining wheel.

  Step 6

Place the wheel pant over the wheel. Position the wheel

pant so it is parallel to the fuselage centerline. Mark the

location for the two screws from the back of the wheel

pant using a felt-tipped pen.

Section 4: Landing Gear Installation