User Manual

 Step 6

Drill a 1/16" (1.5mm) hole in the center of each hinge slot

in both the elevators and stabilizer. Prepare six CA hinges

by placing a T-pin in the center of each hinge. Slide the

hinges into the elevators until the T-pins are resting on the

leading edge of the elevator.

 Step 7

Slide the elevators onto the stabilizer. Remove the T-pins

and use thin CA to glue the hinges. Allow the CA to fully

cure before testing and breaking in the hinges using the

same technique as the aileron hinges.

 Step 8

Since the holes are pre-drilled in the elevator, go

ahead and install the control horn using three

2mm x 12mm screws.

Section 2: Hinging the Stabilizer