User Manual

11
  Step 13
Secure the servo using the screws provided with
the servo.
  Step 14
Slide a clevis retainer onto a clevis. Thread the clevis
onto the 4" (102mm) aileron pushrod wire.
  Step 15
Enlarge the outer hole of the servo arm using a 5/64"
(2mm) drill bit. Attach the “Z” bend to the servo arm.
Note: You may want to use tape at the
wing tip and wing root to hold the aileron
in position for the next few steps.
  Step 16
Plug the aileron servo into the radio system. With the
radio on, center the aileron stick and trim. Position the
aileron servo arm parallel to the hinge line. Thread the
clevis so the pin in the clevis is aligned with the trailing
edge of the wing.
  Step 17
Remove the backplate from a control horn using a hobby
knife. Attach the clevis to the center hole of the control
horn. Use a felt-tipped pen to mark the locations on the
aileron for the three aileron control horn screws.
Section 1: Aileron Installation