User Manual

1. Make sure to install the power switch.

2. Push the sparkplug cap all the way over the sparkplug.

3. Fixate the body within the fuselage, as shown in the diagram. Make sure

that the sponge, cloth or the like is not enclosed.

4. The temperature of the bottom surface (D) of the unit, in particular, will

rise. Thus, when fixating surface (D), make sure to leave sufficient space

(a gap).

The temperature of the unit may rise to as high as 70~80°C,

depending on the operating environment and conditions, but

this is not abnormal. However, make sure not to touch this

part or you could risk being burned.

DC IGNITION UNIT MOUNTING

Sponge & cloth

Gap: 5mm or more

surface D

surface

surface D

Bolt (4mm)

Sparkplug wire

Sensor wire

Unit

Battery wire

For charging

Switch

Capacity: 3A (or higher)

Nic battery 4.8V

1500~2700mA

Use of anything

other than an 4.8V

battery is prohib-

ited.

Ground

wire

surface D